About this Blog

This is about the combination of two interests, Radio Control vehicles and Science Fiction models. This blog documents my science fiction spaceship and radio controlled vehicle projects.

Friday 13 December 2019

Resilient cruiser part 8

I have been working on the cockpit interior of the Resilient project.
I made up a floor and console complete with a couple of 1/48 scale jet pilot figures and their seats.
Added to that are a couple of side panels and a back wall insert.
All were detailed with kit parts from my tiny parts box and then sprayed with a light coat of primer grey.
The detailing doesn't have to be too fussy here as it will be very difficult to see once the model is buttoned up.
I just want an interesting tech panel texture in there to catch the light.
The idea is that the pilots will mostly just be silhouettes when seen through the windows.








The removable roof interior was also tackled and includes a pelmet that diffuses the direct light from the leds mounted at the back, one white in the middle and a red led each side. Each of the leds has the appropriate resistor soldered to the positive lead to run off 12 volts dc.

 


The pelmet is made from a piece of 3mm thick opal perspex with some rectangular and small round frame shaped kit parts. Paint was used to block the light except through the frames and the pelmet positioned to allow some light to spill down the back wall. The photos show the effect.


 




 

  

I have still got to do a little painting to the pilot figures and a bit of weathering to the panels before gluing them in permanently.

Thanks for looking.
More soon...

No comments:

Post a Comment

Most Popular Posts in the Last 7 Days