About this Blog

This is about the combination of two interests, Radio Control vehicles and Science Fiction models. This blog documents my science fiction spaceship and radio controlled vehicle projects.

Friday, 24 July 2026

Submarine Kitbash Spaceship part 4

I believe I have completed the surface detailing phase of the project. 

The plain white panels are mostly cut from 0.5mm styrene sheet.

The rest is a lot of flat panel kit parts and a few bits of evergreen textured sheet..











Next step grey primer.

Thanks for looking.

More soon...


Posted by at
Labels: , , , ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Most Popular Posts in the Last 7 Days

  • Ultraman Towards the Future AKA Ultraman Great part 10
    In one episode the F18 models again feature flying over a miniature landscape with a volcanic anomaly caused by the Goudis monster.   The se...
  • New Spaceship model Part 1
    Here is the beginnings of my new Spaceship project, designed to make use of that old engine section that has been kicking around for years s...
  • Unfinished Old Spaceship model Part 2
    This model was started around the same time as the "Sony" model. It is so close to being finished I don't know why I didn'...
  • Submarine Kitbash Spaceship Part 3
    I added a strip around the back edge to give the rear bulkhead a bit of an inset. The rear bulkhead was then fully detailed out, quite a fid...
  • Moebius-1 part 2
    Part 1 here Most of the large toybashed detail pieces have now been superglued to the underside of the flat top. The final placement diff...
  • Moebius-1 part 5
    Along with some more styrene sheet and kit part detailing, I have added a piping layer to the underside of the Flat Top. The large pipes a...