I started paneling and detailing the flat top side of the moebius-1 project.
It's still a work in progress.
The long grey finned panel at the rear above where the engines sit is a paper guide from an inkjet printer. The two red panels are from the transformers SCVNGR toy.
The rest is an assortment of kit parts, evergreen panels and strips, black 2mm, 1mm and 0.5mm styrene and 3mm and 6mm foamed pvc sheet.
There is still more paneling and piping to be done as well as a fine detail pass.
Thanks for looking.
More soon...
About this Blog
This is about the combination of two interests, Radio Control vehicles and Science Fiction models. This blog documents my science fiction spaceship and radio controlled vehicle projects.
Sunday 7 October 2018
Moebius-1 part 4
Subscribe to:
Post Comments (Atom)
Most Popular Posts in the Last 7 Days
-
This model was started around the same time as the "Sony" model. It is so close to being finished I don't know why I didn'...
-
Almost 10 years ago in 2015 I did a post called Giant Tyres and DIY PVC wheels . In that post I showed a method of making some beadlock whe...
-
The last three spaceships actually got finished. This one however never has been finished as I was never happy with the way it looked. Over ...
-
To test out my idea of one geared motor per wheel in a spin steer vehicle I built a quick chassis out of wood. The purpose was to test whet...
-
Readers of this infrequent blog will know I have an obsession with massive RC tyres and recently I acquired 3 pairs of the biggest RC t...
-
Some progress has been made on the detailing of the Explorer hull. The black bits are 1mm styrene sheet. the corner triangles are 2mm...
One more awesome scratchbuilding Mung!
ReplyDeleteThanks a lot for sharing