I also removed most of the rivets.
Next up is some more detail to be added to the engine casings.
part 1, part 2, part 3, part5
More soon....
Designing, scratchbuilding and kitbashing Sci fi Spaceships and radio controlled vehicles.
Sunday, 10 April 2016
Kit Bash Shuttlecraft part 4
Some modifications have been done which I think will go a long way to
camouflage the obvious "helicopter" canopy and some extra detail has
been added to the sides.
I also removed most of the rivets.
Next up is some more detail to be added to the engine casings.
part 1, part 2, part 3, part5
More soon....
I also removed most of the rivets.
Next up is some more detail to be added to the engine casings.
part 1, part 2, part 3, part5
More soon....
Subscribe to:
Posts (Atom)
Most Popular Posts in the Last 7 Days
-
Here is the beginnings of my new Spaceship project, designed to make use of that old engine section that has been kicking around for years s... -
This model was started around the same time as the "Sony" model. It is so close to being finished I don't know why I didn'... -
The thing that many RC vehicles lack is a driver or Pilot figure. To me, a model vehicle just doesn't look right without a figure to pop... -
This model was made in the late 90's. It was again made from a disparate collection of shapes. There is a central spine made of some PV... -
The Ultraman production purchased a collection of miniature buildings that were originally made for an unfinished version of Total Recall ... -
I added a strip around the back edge to give the rear bulkhead a bit of an inset. The rear bulkhead was then fully detailed out, quite a fid...