I have flipped the model over and resumed working on the top again.
I have been trying to finish the communications tower and I think it's done.
I sprayed some grey primer just to make sure.
The whole communication tower assembly has been made removable for safer transport in the future. It has a number of small and fragile antenna arrays.
It is held onto the model with a strong magnet near the front and a small lip that mates with a tab at the rear.
Thanks for looking.
More soon...
About this Blog
This is about the combination of two interests, Radio Control vehicles and Science Fiction models. This blog documents my science fiction spaceship and radio controlled vehicle projects.
Sunday 1 December 2019
Resilient cruiser part 7
Subscribe to:
Post Comments (Atom)
Most Popular Posts in the Last 7 Days
-
This model was started around the same time as the "Sony" model. It is so close to being finished I don't know why I didn'...
-
I completed scribing panel lines over the plainer areas of the surface and then finished up with spot putty and more grey primer. I was try...
-
This model was made in the late 90's. It was again made from a disparate collection of shapes. There is a central spine made of some PV...
-
I have been on a bit of a roll completing two projects in quick succession and have been endeavoring to continue on with that theme and comp...
-
There hasn't been much modeling going on for a while now as I was laid off at work and have been scrambling to find some employment. No...
-
With a dozen or so of unfinished projects lying around I started a new one I call the Space Barge. Over a year ago I purchased a couple o...
No comments:
Post a Comment